ELMAG START-UP SERVICE
A high-quality machine is an investment – and it should run reliably right from the very first time it is used. That is exactly what the ELMAG START UP SERVICE is all about. Before your machine leaves our premises, our professionally qualified and trained technicians personally inspect it and subject it to a comprehensive ELMAG quality check. You will not receive a machine that you first have to assemble and set up, but a tested, adjusted and fully operational unit.
From removing the preservative coating to filling gearboxes and applying lubricants, right through to testing all electrical, safety and machine functions, every relevant aspect is checked – including a detailed test run at all power levels. This is how we ensure that the tolerances are correct, all functions work flawlessly and your machine is ready for use exactly when you are.
For you, this means less effort during commissioning, time saved and the certainty of receiving a machine that has been checked and approved by professionals. This personalised service has always been an integral part of ELMAG’s added value – and one of the reasons why our customers trust ELMAG.
Metalworking
✓ Removal of preservative, degreasing and removal of safety locks
✓ Assembly through to operational readiness
✓ Filling gearboxes, oil baths and central lubrication systems with oil
✓ Testing of electrical systems, safety components and devices
✓ Test run at all gear and power settings
✓ 30-minute test run at the highest power stage
✓ Checking and, where necessary, adjusting machine tolerances, e.g. V-belt tension and spindle concentricity
✓ Check of all machine functions
For lathes, additionally
✓ Re-fitting of the chuck with marking of the minimum tolerance
✓ Measurement of the spindle nose to a tolerance of < 0.01 mm
✓ Measurement of the lathe chuck
✓ Adjustment of tailstock parallelism
Welding technology*
✓ Assembly of the system, mounting of the chassis
✓ Fitting of mains plug, gas hose and intermediate hose assembly
✓ Preparing connections for gas and compressed air
✓ Fitting of control cable connectors to the hose assembly
✓ Installation / commissioning of the water cooling unit for modular systems
✓ Filling with coolant for liquid-cooled systems
✓ Brief test run or test welding
*For MIG/MAG/MMA/TIG welding machines,
plasma cutting systems and induction heating units, depending on the type of equipment
Generators
✓ Refilling with operating fluids
✓ Installation and configuration of the necessary control and monitoring programmes
✓ Testing of all functions and operational readiness during a trial run
Good to know – Delivery time
The preparation as part of the START UP SERVICE is carried out individually according to your order. Please therefore allow for an additional 2–3 weeks’ delivery time – to ensure your machine arrives at your premises fully tested and ready for use.
